HemaTrax Unit ID Sets – Print Sequential Unit ID Set Numbers and Replicate

1. In the windows Program Files directory, locate the Digi-Trax Corporation sub-directory and double-click on it. 
2. If no other HemaTrax program is installed, only the HemaTrax Unit ID Set program folder will be listed. Figure below shows multiple HemaTrax applications including the HemaTrax Unit ID Set program.

3. Double-click on the HemaTrax Unit ID Set folder. Figure below shows sub-folders and files associated with the HemaTrax Unit ID Set program.

4. Locate the Format folder and double-click on it. If no replicant Unit ID Set format has been added previously, only one format will be available as shown below.

5. Now save the copy of the FORMAT6M.FMT into the
   C:\Program Files\Digi-Trax Corporation\HemaTrax Unit ID Set\Format folder.
6. Run HemaTrax Unit ID Set program.
7. From the HemaTrax ISBT-128 Unit ID main window, click on Setup menu then select and click on the Replicant Unit Id Format item from the drop-down selections.
8. In the Replicant Unit Id Format window, select the FORMAT6M item from the combo box selections then click on the OK button. Note that only two selections will be available from the combo box: FORMAT and FORMAT6M.
9. Click on Maintenance from the main menu window and select then click on the Unit Id Sets item from the drop-down selection.
10. In the Unit Id Sets window, enter a new name in the Unit Title combo box. Now select the label format name FORMAT6M item from the Label Format Name combo box selections. Supply all other necessary Unit ID Sets information for this new label set then click on the Add button to save. Close the Unit ID Sets window.

 Note: To continue using the existing Unit Id Sets that uses the old Unit ID Set label layout (FORMAT), create a new Unit ID Set label set that will now use the new FORMAT6M format for the new Unit ID Set label layout.

11. From the HemaTrax ISBT-128 Unit ID main window, click on the Print Labels then select and click on the Unit Id Sets item from the drop-down selections.
12. In the Unit Id Sets window, select the just created new label set in the Unit Title combo box.
13. For Sato CL-412 series printer, adjust the horizontal offset position in the Adjust Position window from the Replicate Unit Id Set window to 3 (in mm). For Zebra Z4M series printer, adjust the horizontal offset position and vertical offset position in the Adjust Position window from the Replicate Unit Id Set window to 1.5 and -1 (in mm) respectively. Print and verify barcode and text positions in the labels -- adjust value if necessary.

Note: When replicating Unit ID Sets number, make sure you also adjust the Horizontal Offset  in mm to 3 in the Adjust Position window from the Replicant Unit Id Set window.

14. END OF PROCEDURE.